4runner misfire p0306

This topic has 1 reply, 2 voices, and was last updated 4 years, 1 month ago by Naughty Nate.

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
May 27, 2020 at 4:37 pm #201663
AlexG
Participant
Hello!

I am having the exact same problems as in the video:

2004 Toyota 4Runner P0306 Misfire Diagnosis

Except it is on cylinder 4.

I don’t have a compression tester but I would like to pull plug #4, disable fuel and ignition, crank, and watch for water vapor to exit the spark plug hole.

My question: How did you disable the fuel injectors without removing the intake?!?! I thought pulling the relay would not allow cranking. Did you just disconnect the spark plug plugs to disable ignition?

Please help!

Thank you!
September 24, 2020 at 3:55 am #262074
Naughty Nate
Participant
Pretty late response, but you could disable fuel by pulling the fuel pump relay and letting the vehicle idle until it sputters out of gas. When you are ready to start it again, turn key forward and wait 3-4 seconds, turn off, turn forward and wait 3-4 seconds and then it should start right up.
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Join the Community

This Website is the ultimate resource for Advanced DIY Auto Repair with the specific purpose of preventing “parts changing”- that is- changing parts on a guess because of a lack of understanding on how to test if a part is actually faulty. This is accomplished by using a methodical, scientific approach to accurately confirm a diagnosis before attempting a repair. Subscribe here and you’ll stop firing the “parts cannon” by changing O2 sensors, plugs, and wires to try and fix your check engine light and instead use professional-level advanced Auto diagnostics and repair with tools and equipment available to any home mechanic.